Bork CH BRE 1818 SI User Manual download pdf (Page 30)

Oscillating ceramic heater with thermostat CH BRE 1818 SI

Remote control

NOTE: It is normal for the heater to cycle ON and OFF as it maintains

the set temperature.

NOTE: When adjusting set temperature, the set temperature on

display will flicker for 5 seconds and the heater will stop oscillating. In

5 seconds, if not to rotate the Power & Thermostat knob, LED will stop

to flicker and display room temperature and restart to oscillate.

REMOTE CONTROL

1. Plug the heater into outlet and open the power switch on the

base.

2. Press the POWER button will start the heater.

3. The OSC., SET TIME and MODE buttons function in the exact same

manner as listed in the OPERATION instructions above.

4. The TEMP. buttons (+,-) are for the thermostat function in the exact

same as the Power & Thermostat knob.

5. The remote control is powered by two AAA batteries. There is a

cover on the back of the remote control that can be removed for

replacement of the batteries as required.

6. Do not mix old and new batteries, or batteries of different

specifications.

1 2 ... 25 26 27 28 29 30 31 32

No comments

Bork CH BRE 1818 SI User Manual Page 30